Aluminum Honeycomb Panel FAQ

Frequently asked questions on aluminum honeycomb panel
(1) the connection code elements firmly fixed, offset.
(2) not straight code installed.
(3) aluminum honeycomb panel Board itself is not flat.
(4) plastic injection parts clean.
(5) plastic seam depth is too large, resulting in bonding on three sides.
(6) rubber in before they are fully bonded by dirt contamination or damage.
(7) the keel and annex flatness error too large, gaps between plates are reserved is incorrect.
(8) embedded parts set off when installing baseline.
(9) embedded parts and formwork, reinforcement of connections is not strong, so that when the concrete position changes.